ADT Doorbell Flashing Red While Charging : Easy Fix

The flashing of a red light can indicate several things, from a low battery to a charging issue. Understanding why your ADT Doorbell is flashing red is important to ensure its proper functioning and secure your home. Many users have experienced this problem and by implementing a few simple steps, you can fix the issue.

So, are you wondering why the ADT Doorbell Flashing Red While Charging? Well then, here in this blog, we’ll provide you with some quick and easy steps that will help you in fixing the issue easily. Keep going with the blog to understand the reason for the ADT Doorbell flashing red while charging, along with some possible steps to address the issue effectively.

ADT Doorbell Blinking Red: Why?

The two most common causes of your ADT doorbell camera glowing red are as follows:

Step 1: The camera's battery will soon run out, and you have to recharge it, and

Step 2: For the ADT system to function as intended, the internet connection must be more reliable than it now is.

Step 3: Let's start with the Wi-Fi issue since it is much simpler to resolve than the battery charge issue.

Step 4: Keep bringing up your ADT Pulse application and check what's happening in your Wi-Fi.

Step 5: The connection may be down entirely for some reason, the router isn't functioning exactly as intended, or the signal isn't as powerful as it typically is.

How is the Battery For the ADT Doorbell Camera Charged?

Based on when you receive the signal, you may have only a few hours or a whole day left of your batteries. Because of this, you need to act quickly to solve the issue, connect your charger, and start charging the security part.

adt doorbell blinking red while charging

It would be best if you first took off the faceplate of your doorbell to get to the rechargeable connector.

Once you've taken care of all that, you'll like to put in a tiny USB wire to the charging port to pump electricity to the device and charge the battery to 100%.

Your battery may take 45 minutes or longer to recharge (though it rarely does) fully, but once it does, you must be ready to go for a further few weeks.

Keep charging your ADT doorbell until the light turns blue again, indicating that the battery has been fully recharged. Replace the faceplate, unplug the USB cord, and you're ready to rock!

Conclusion

The troubleshooting advice we've offered in this article will solve your issue if you're utilising a wireless ADT system. However, be cautious to inspect the wiring and the voltage fluctuations if you utilise a non-wireless/hardwired system.