How to Factory Reset Your Ring Alarm Devices?

Factory resetting the ring alarm devices is an important step in correcting different issues. Whether you’re facing the issue consistently or occasionally, knowing how to factory reset the device is essential. Factory resetting removes all the bugs and restores the device to its default setting. By following a few simple steps, you can factory reset the ring alarm device.

Many users look for ways to factory reset the ring alarm device. So, are you also looking for ways How To Factory Reset Your Ring Alarm Devices? Well then, in this blog, we’ll provide you with some simple and quick steps that will help you in factory resetting the ring alarm devices.

Factory Reset Ring Alarm Base Station:

Factory Reset Ring Base Station-

NOTE: Do not try to reset the ring alarm base station on your own. Kindly contact to Netgear care and ask for their guidance and assistance if you are facing any kind of problem with your ring alarm.

Factory Reset Ring Contact Sensor-

Step 1: Take the cover from the device.

Step 2: Take out the battery from the device.

Step 3: Long Press the tamper button which you will find near the antenna.

Step 4: Put the battery back while still holding the tamper button. You will see the LED light flash. Keep hold of the button until the LED light turns off.

Step 5: Put the cover of the device back on.

Factory Reset Ring Motion Detector-

Step 1: Long press the reset button which you will find under the pinhole on the back of the motion detector. You can do this using a paper clip.

Step 2: You will see the LED blinking. Long press the button until it stops blinking.

Step 3: Take off the cover of your motion sensor.

Step 4: Take out the battery.

Step 5: Put the battery back.

Step 6: Put the cover of the device back.

Factory Reset Ring Keypad-

Step 1: Long press number “5” key with your keypad plugged in.

Step 2: While holding the number “5” key, press the reset button under the pinhole on the backside of the device with a paperclip.

Step 3: You will see the keypad light up for a while and then you will see the network icon on the top left flashing.

Step 4: Release number “5” key when the network icon stops flashing.

Factory Reset Ring Range Extender-

Plugin the extender and long-press the button on the side of the extender. The LED on the device will start blinking rapidly. When lit starts blinking slowly, you can release the button.

Factory Reset Ring First Alert Smoke and Co Detector-

The device is to be powered up by pressing the test button for 10 seconds. This will leave the network mode and reset all the z-wave settings. This will put the device on stand by mode.

Factory Reset Ring Flood and Freeze Sensor-

Long press the setup button which you will find on the side of the sensor with battery and wait for the LED to stop flashing. This will take approximately 10 seconds.

Factory Reset Ring Panic Button-

Long press the setup button which you will find on the side of the sensor with battery and wait for the LED to stop flashing. This will take approximately 10 seconds.