How to Fix Schlage Lock Not Working After Battery Change?

Did you replace the batteries in your Schlage Keypad lock, but it still wouldn't work? If that is the case, keep reading because I'll explain why it might be occurring and what you can do to fix it. Let's get going! If your Schlage Lock Not Working After Battery Change, it can be due to improper battery placement, the use of the wrong batteries, and lock malfunctions.

How to Fix a Schlage Lock that Fails to Operate After Changing the Batteries

Verify that the Batteries are not Improperly Installed.

Before trying other troubleshooting techniques, ensure the batteries in your lock are inserted properly, even though this is an unusual source of the issue. If the batteries are not fitted properly, your lock won't function; therefore, double-check and arrange the batteries properly.

Remove the Batteries from Schlage Lock

Try the following workaround if your lock is still not functioning despite the battery type and installation being correct:

The batteries in the lock must be disconnected and taken out.
The exterior Schlage button should be repeatedly pressed and released.
Reconnect the battery connector cable and turn the battery back on after waiting 30 to 60 seconds.
Verify the issue has been resolved. If not, move on to the following action.

Verify the Schlage Lock Battery Connections

Checking the condition of the battery terminals in your lock is another troubleshooting step you can take.
Even after replacing the old batteries, a lock may not function because dead batteries leak acid and damage the battery contacts.
And this typically occurs if the old batteries had bad seals or died and were left in the lock for a while before being changed.
To ensure that the batteries correctly contact the terminals, look for any corrosion or acid leaks on the terminals and clean them.
To clean the terminals of corrosion, use vinegar or lemon juice. Wipe the battery terminal surface lightly with a Q-Tip after dipping it in lemon or vinegar.

Grab a Factory Reset on Schlage Lock

You will then investigate the lock for hidden bugs if none of those, as mentioned earlier, fixes succeed. And performing a factory reset on the lock is an easy way to do this.

Having stated that there is a reset procedure for a Schlage keypad lock:
Disconnect the batteries after removing the battery cover.
Release the Schlage button after pressing it.
Attach the batteries in ten seconds, then push and hold the Schlage button until you hear the lock beep once and see a green light appear.

Your lock has been reset, which should fix the issue you were having with it. After the reset, if the issue still exists, get assistance from Schlage Customer Support.

Conclusion

As you can see, there could be some causes for your Schlage keypad lock not functioning, but you can fix it by attempting the numerous troubleshooting techniques listed above.

After testing one of the troubleshooting procedures, if your Schlage Lock Not Working After Battery Change, move on to the next step to see if it solves the problem. That's all, then! This information was useful to you, and you resolved the issue with your Schlage keypad door lock.