How To Reprogram A Chamberlain Garage Door Opener?

You may have gotten stuck up while trying to open the door of the Chamberlain garage door opener which you can fix by following either of a few do-it-yourself ways mentioned in this quick guide. So whenever you wish to reprogram a Chamberlain Garage Door Opener just draw reference from this guide that is suitably drafted to help you fix the same.

Also Read: How to Reset Garage Door Keypad Without Code?

By Deleting the Door Opener’s Memory

To reprogram a Chamberlain Garage Door Opener you must delete the existing program codes in the following way.

Step 1 - Simply begin by finding the “Learn” button at the back of the motor housing

Step 2 - Continue by long pressing the “Learn” button for at least six seconds until the LED next to it turns off.

Step 3 - In the end just reset the garage door opener and erase all programming data and codes.

By Reconnecting the Remote of Your Chamberlain Garage Door Opener

In this very step, you should program the remote control of the Chamberlain Garage Door Opener by adhering to the steps for the given model. In case you have forgotten the model of your garage door opener, just look at the color of the “Learn” button since the color on the “Learn” button corresponds to the frequency of pressing the “Learn” button.

Color of LEARN Button No. of Presses Garage Door Opener Model
Yellow 1 Security+ 2.0
Purple 2 315 MHz Security+
Red/Orange 3 390 MHz Security+
Green 4 390 MHz Billion Code

Please note that when you start to reprogram a Chamberlain Garage Door Opener, you are provided with only 30 seconds to accomplish the process.

Now on the remote control of Chamberlain Garage Door Opener, just find the metal chip inside a hole. It can be easily found on the side or at the back behind a vizor. Long press this button using a straight and rigid wire. In this regard, a paper clip can also be used.

Step 1 - Continue pressing this metal chip till you see the light getting emitted. As and when it does you will have a maximum of 30 seconds to reprogram a Chamberlain Garage Door Opener.

Step 2 - Now press and release the “Learn” button on the garage door opener.

Step 3 - Then finally press the desired button on the remote relating to the number of times one is required to press in accordance with the color of your “Learn” button.

By Reprogramming the Keypad

Step 1 - Here you have to press the “Learn” button followed by completing the process after the light turns on.

Step 2 - Continue by punching in the 4-digit code and pressing the “Enter” key till the time you hear a click.

Step 3 - Now click “f” when the light bulb starts flashing.

Step 4 - Finally, press the “Enter” button on the keypad and wait for the garage door to close and further check whether the garage door opens by entering the 4-digit code.